 |
Insertion Magnetic Flow Meters |
 |
|
Series MFX
|
|
|
Series MFX Insertion MagProbe™ Flow Meters are
a cost-effective solution for accurate measurement of conductive liquid flow
in closed conduit, pressurized-pipe applications. The MFX system
consists of a hot-tappable insertion-type sensor
that mounts through a 1-1/2" ball valve pipe-tap into the flowing liquid and
a remote digital display enclosure. The digital display is utilized to
program engineering units, view flow rate/totalizer values and provide
process outputs. Velocity and pipe diameter information are entered by the
user via the display keypad or ULTRALINK™ software and
used to calculate volumetric flow, over wide flow ranges, with a high degree
of accuracy.
The Series MFX is more versatile and convenient than most conventional
full-pipe magnetic meters. MFX meters can be universally applied to a large
range of pipe sizes without hardware changes, compared to the specific
internal pipe dimension design of conventional magnetic meters. In addition, cost differences are minimal when moving to larger pipe sizes. MagProbe
sensors are available in various lengths to accommodate limited access
mounting configurations and installation in pipe internal diameters from 4 to
120 inches (102 to 3048 mm).
The MFX reliably measures most conductive fluids including water, sewage,
wastewater, clarified water, RAS, WAS, primary sludge and cooling tower
water, as long as adequate lengths of straight pipe are available where the
sensor is installed.
Additional MagProbe features include:
- Absolute (bi-directional) measurements from 0.1 to 30 FPS (0.03 to 9 MPS)
- Integrated sensor pre-amplifier permits separation of up to 990 feet (297 m) between
the sensor probe and MFX electronic analyzer
- Optional optically isolated, field replaceable input/output modules include: 4-20 mA,
dual-relay, rate pulse, RS232 and RS485
- Hot-tap sensor can be installed and retracted from process piping without draining
or depressurizing the system
- High impedance input circuits minimize the influence of electrode coating
- Industrial-grade sensor design: NEMA 6 (IP 67) submersible, temperature to
225 °F (105 °C), pressure to 700 PSIG (48 barg), titanium, 316SS, Viton® and PVDF
wetted materials
- ULTRALINK™ PC utility permits configuration and intelligent diagnostics to be performed
|
Viton is a registered trademark of E.I.DuPont Nemours and Company.
|
|
